Faq's

1. PULLEY ALIGNMENT
2. USE OF PROPER GUARD
V-belt Pulley
Ensure pulleys are perfectly aligned.
Use of proper guard
Ensure grooves are free from burrs, sharp edges, rust, oil and grease. Proper wire mesh guard may be provided to save the drive & also personnel.
 
3. MIXING OF BELTS
4. INSTALLATION OF V.BELTS
Mixing of V-belts
Do not mix the belts different manufacturer
Installation of V-belts
Do not install the belts into the pulley grooves with the help of any tool eg. screw driver, iron rod because of this belts gets damage internally resulting in lesser life. Use drive take up allowance helping in easy installation on the pulleys.
 
5. CORRECT USE OF BELTS
6. WORN OUT PULLEY/BELT
Correct use of belts
For higher service life and low maintenance and better results use only Match set belts. Belts should not be lubricated for any reason.
Worn out pulley belt
The change in seating position clearly indicates worn out belt or sheaves. Replace pulley/belt with new one.
 
7. Ensure pulleys are as per international standard and bearings are properly lubricated
Pulleys are perfectly aligned